Szczegóły publikacji

Opis bibliograficzny

Impact of regeneration on the dosimetric properties of LiF:Mg,Cu,P (MCP-N) detectors / Patrycja Gordon, Katarzyna MATUSIAK, Mariusz Kłosowski, Aleksandra JUNG // Sensors [Dokument elektroniczny]. — Czasopismo elektroniczne ; ISSN  1424-8220 . — 2026 — vol. 26 iss. 16 art. no. 5176, s. 1–22. — Wymagania systemowe: Adobe Reader. — Bibliogr. s. 20–22, Abstr. — Publikacja dostępna online od: 2026-08-15

Autorzy (4)

Słowa kluczowe

LiF:Mg,Cu,P (MCP-N) detectorsreadout mode reproducibilitythermoluminescent dosimetryglow-curve analysisdetector regeneration

Dane bibliometryczne

ID BaDAP169671
Data dodania do BaDAP2026-09-28
Tekst źródłowyURL
DOI10.3390/s26165176
Rok publikacji2026
Typ publikacjiartykuł w czasopiśmie
Otwarty dostęptak
Creative Commons
Czasopismo/seriaSensors

Abstract

This study evaluates the dosimetric properties of standard (SD) and regenerated (RD) MCP-N thermoluminescent detectors over a wide dose range from mGy to Gy, with particular emphasis on the influence of readout mode, dose level, and temporal stability on detector performance. A total of 17 SD and 18 RD detectors were analyzed under standard conditions using two readout modes: a three-step READER mode and a continuous ANALYSER mode. Both detector types exhibit good linearity; however, deviations from ideal behavior at higher doses suggest the involvement of additional trapping and recombination processes. Glow-curve analysis indicates modifications in RD detectors, reflected by enhanced low-temperature peaks and slight shifts in peak position. Temporal effects also influence detector response, with stabilization observed after repeated irradiation–readout cycles. Fading remains low, with relatively stable signal levels over time. The results show that the ANALYSER mode provides improved stability and reproducibility compared to the READER mode, especially at higher doses, where increased variability and certain limitations were observed. Overall, regenerated detectors, despite reduced sensitivity, achieve performance comparable to standard detectors after stabilization. Optimization of readout conditions, particularly the use of ANALYSER mode, is essential for ensuring reliable dosimetric performance across a wide dose range.

Publikacje, które mogą Cię zainteresować

artykuł
#106684Data dodania: 13.7.2017
Comparison of MCP-Ns and MCP-N detectors usefulness for beta rays detection / Katarzyna MATUSIAK, Aneta Patora, Aleksandra JUNG // Radiation Measurements ; ISSN 1350-4487. — 2017 — vol. 102, s. 10–15. — Bibliogr. s. 15, Abstr. — Publikacja dostępna online od: 2017-06-02
artykuł
#132525Data dodania: 17.2.2021
The impact of accidental immersion in selected liquids on the sensitivity and repeatability of MCP-N thermoluminescent detectors / A. JUNG, K. MATUSIAK // Radiation Measurements ; ISSN 1350-4487. — 2021 — vol. 141 art. no. 106525, s. 1–6. — Bibliogr. s. 6, Abstr. — Publikacja dostępna online od: 2021-01-24