Szczegóły publikacji
Opis bibliograficzny
SPHIRD–single photon counting pixel readout ASIC with pulse pile-up compensation methods / P. GRYBOŚ, R. KŁECZEK, P. KMON, P. OTFINOWSKI, P. Fajardo, D. Magalhães, M. Ruat // IEEE Transactions on Circuits and Systems. II, Express Briefs ; ISSN 1549-7747. — 2023 — vol. 70 no. 9, s. 3248–3252. — Bibliogr. s. 3252, Abstr. — Publikacja dostępna online od: 2023-04-18
Autorzy (7)
- AGHGryboś Paweł Leonard
- AGHKłeczek Rafał
- AGHKmon Piotr
- AGHOtfinowski Piotr
- Fajardo Pablo
- Magalhães Debora
- Ruat Marie
Słowa kluczowe
Dane bibliometryczne
| ID BaDAP | 148266 |
|---|---|
| Data dodania do BaDAP | 2023-09-19 |
| Tekst źródłowy | URL |
| DOI | 10.1109/TCSII.2023.3267859 |
| Rok publikacji | 2023 |
| Typ publikacji | artykuł w czasopiśmie |
| Otwarty dostęp |  |
| Czasopismo/seria | IEEE Transactions on Circuits and Systems, II, Express Briefs |
Abstract
This paper presents the design and measurement results of a prototype SPHIRD-1 ASIC in the CMOS 40 nm process. The chip is dedicated to high count rate single photon counting operation at the European Synchrotron Radiation Facility with Extremely Brilliant Source. The core of the prototype IC is the matrix of 64 32 pixels of 50 μm pitch. Each pixel contains a Charge Sensitive Amplifier (CSA) with a fast discharge block and a detector leakage current compensation circuit. The CSA is connected to a set of three discriminators. The readout channel is equipped with additional circuits, which provide different pulse pile-up compensation methods. The priority of the analog front-end electronics is to process the input signal in a short time (the CSA output pulse time width is only 18 ns) and to keep low noise (the equivalent noise charge at the level of 188 el. rms) with a power consumption equals to 26 μW/pixel. The chip is optimized for operation with a monochromatic X-ray beam with an energy of up to 30 keV. The measurements prove the possibility of counting up to 11.5 Gcps/mm2 based on a 10% dead time loss input rate parameter.
