Szczegóły publikacji
Opis bibliograficzny
Investigation of the impact of selected face milling parameters on the roughness of the machined surface for 1.4301 steel / Michał BEMBENEK, Damian DZIENNIAK, Agnieszka DZINDZIORA, Maciej SUŁOWSKI, Liubomyr Ropyak // Advances in Science and Technology Research Journal [Dokument elektroniczny]. — Czasopismo elektroniczne ; ISSN 2299-8624. — 2023 — vol. 17 iss. 4, s. 299–312. — Wymagania systemowe: Adobe Reader. — Bibliogr. s. 310–312, Abstr. — Publikacja dostępna online od: 2023-08-15
Autorzy (5)
Słowa kluczowe
Dane bibliometryczne
| ID BaDAP | 148120 |
|---|---|
| Data dodania do BaDAP | 2023-08-30 |
| Tekst źródłowy | URL |
| DOI | 10.12913/22998624/170422 |
| Rok publikacji | 2023 |
| Typ publikacji | artykuł w czasopiśmie |
| Otwarty dostęp |  |
| Creative Commons | |
| Czasopismo/seria | Postępy Nauki i Techniki |
Abstract
The objective of this research was to analyze how different milling parameters impact the roughness of the surface produced during the machining process. Kinematic parameters, such as cutting speed and feed per tooth, as well as geometric parameters, such as axial and radial depth of machining, were considered in various configurations to determine which one had the greatest impact on the surface quality of 1.4301 stainless steel (also known as AISI 304, among other designations). This type of steel is commonly used in a number of industries, such as construction, automotive, food, chemical, decoration, oil, and petrochemical, owing to its favorable properties. It is also relatively cheap. The analyzed roughness parameters included Ra, Rq, Rz, Rt, which, considered collectively, provide a comprehensive picture of the overall surface quality. Based on the results, feed per tooth is the one parameter that was to a large degree responsible for the overall quality roughness of the surface of the analyzed samples. The remaining tested parameters also had an impact on the surface quality, which resulted in a dynamic increase or decrease in roughness (extremes), but not to the same degree as in the case of feed per tooth. At one point, for a relatively low axial depth of cut, a sudden increase in the resulting roughness was recorded.
