Szczegóły publikacji
Opis bibliograficzny
On ausferrite produced in thin sections: stability assessment through round and flat tensile specimen testing / Giuliano Angella, Riccardo Donnini, Dario Ripamonti, Franco Bonollo, Bogdan Cygan, Marcin GÓRNY // Metals [Dokument elektroniczny]. — Czasopismo elektroniczne ; ISSN 2075-4701. — 2023 — vol. 13 iss. 1 art. no. 105, s. 1-26. — Wymagania systemowe: Adobe Reader. — Bibliogr. s. 24-26, Abstr. — Publikacja dostępna online od: 2023-01-04
Autorzy (6)
- Angella Giuliano
- Donnini Riccardo
- Ripamonti Dario
- Bonollo Franco
- Cygan Bogdan
- AGHGórny Marcin
Słowa kluczowe
Dane bibliometryczne
| ID BaDAP | 144456 |
|---|---|
| Data dodania do BaDAP | 2023-01-12 |
| Tekst źródłowy | URL |
| DOI | 10.3390/met13010105 |
| Rok publikacji | 2023 |
| Typ publikacji | artykuł w czasopiśmie |
| Otwarty dostęp |  |
| Creative Commons | |
| Czasopismo/seria | Metals |
Abstract
Ductile irons were produced into different casting wall sections, that is, 25 mm, 5 mm and 3 mm. The alloys were then austenitized with the same conditions at 875 °C for 2 h and austempered for three different combinations of temperatures and times: 250 °C for 6 h, 310 °C for 3 h and 380 °C for 1 h. The aim of the investigation was to study the ausferrite stability of austempered ductile irons with three different nominal contents of nickel produced in thin sections through tensile testing. So, strain hardening analysis of tensile flow curves was carried out since it has been found to be a reliable support to ductility analysis in assessing the optimal austempering conditions. Because of different wall sections, round and flat tensile specimens with geometries complying with ASTM E8/E8M-11 were tested. Austempered ductile irons from 5 and 3 mm wall sections were tested through flat geometry specimens only, while 25 mm wall sections were tested through both round and flat geometries. Though the ausferrite was affected by Ni content and the graphite morphology was improved with reduced thin sections, the ausferrite stability and the tensile mechanical behavior were insensitive to Ni content and section thickness below 25 mm. Furthermore, it resulted that the tensile plastic behavior was sensitive to the specimen geometry in a consistent way, increasing the instability of ausferrite and indicating that a proper analysis and comparison of tensile properties of austempered ductile irons must take into account the tensile specimen geometry.